Kamp Rats Forums  

Go Back   Kamp Rats Forums > Power Toys > ATVs- buggies, UTVs-quads-motorcycles
Register Members List Forums Photo Gallery Calendar Search Today's Posts Mark Forums Read

ATVs- buggies, UTVs-quads-motorcycles Discussion of sandrails, UTVs, quads and all other All Terrain Vehicles.

Thread Tools
Old May 20th, 2017, 09:46 AM   #1
ahh, back on the piz route
Clubjoe's Avatar
Join Date: Nov 2006
Location: Bako, CA
Posts: 3,956
Cool Rhino hub stud fix

Did a DIY fixer on my rear Rhino hubs, and I thought I'd pass it along.

I spun two rear hub studs (10mm) and It looked like I was going to have to buy a new or used hub assembly. After whining about the cost of hub assemblies with potential same problems, I decided to see if I could cheap out on a reliable fix. I have a spacer bolted to my hub studs, and the wheels bolt onto the spacer studs. The rear spacers are always on, and the holes were 12mm.

What I did was knock out the hub studs, and I found the splines were 12mm diameter. I replaced them with 12mm allen head bolts with 1/2 inch drive flange wedge washers to serve as lug tapers for the spacers. Nylox nuts fastened them on the rhino side of the hubs.

There's no play or chance of spinning splines, the hub studs are now 12mm instead of 10mm and the hardware for both sides was about 2/3 the cost for one hub assembly.

And I didn't break anything!
- -
Clubjoe is offline   Reply With Quote

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -8. The time now is 03:57 PM.

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2021, Jelsoft Enterprises Ltd.